Access/Start System Antenna In Luggage Compartment R137

Access/Start System Antenna In Luggage Compartment R137

Component location of Access/Start Authorization Antenna in Luggage Compartment is in luggage compartment, at center in front of spare wheel well.

• No coding, basic setting or adaptation is necessary if Access/Start Authorization Antenna in Luggage Compartment is replaced. Erase the entry in the DTC memory via "guided fault finding" with the Vehicle Diagnostic Tester.

Removing

• The alignment and exact position of the antennas are crucial for their function. Before removing antennas in the passenger compartment, mark the exact position and alignment of antennas and secure them in exactly these positions and alignments when installing. The thickness of the adhesive pad layer on antennas is an integral part of their function. If the bond of one antenna loosens, do not reapply standard adhesive on it. In this case, a new antenna must be installed with a new adhesive pad. If this is not done, the KESSY system will malfunction.

- Switch off the ignition and all electrical consumers and move the ignition key or start button into the 0 position (preliminary engaged position).

- Remove the luggage compartment floor panel..

- Disengage and disconnect harness connector - 2 - and remove adhesive of Access/Start Authorization Antenna in Luggage Compartment - 1 -.






- Remove Access/Start Authorization Antenna in Luggage Compartment - 1 - from vehicle.

Installing

Install in reverse order of removal. Note the following:






- Before bonding, align antenna at both markings - arrows - on edge of spare wheel well.

- Bond on the Access/Start Authorization Antenna in Luggage Compartment within these markings so that lower edge of antenna housing lies 4-5 mm above upper edge of spare wheel well edge.