Removal and Replacement

Fuel Level Sensor (G)

Removing

- Remove the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] Fuel Delivery Unit.

- Move the fuel level sensor slightly to the side and upward at the same time.






- Push the tabs - arrows - slightly to the side if the sensor does not unlock.






- Write down the colors of the wire for installation later.

- Disconnect the wire connectors - 1 through 3 - and bend back the hooks on the connectors.






Installing






- Connect the wire connectors - 1 through 3 -. Pay attention to the color coding.

- Pull on the connector to make sure it is secure.

- Insert the fuel level sensor in the guide on the fuel delivery unit and push down until it engages.

- Install the fuel delivery unit. Refer to => [ Fuel Delivery Unit ] Fuel Delivery Unit.

Tightening Specifications