Evaporative Emission Control Canister: Service and Repair

EVAP Canister

Removing

- Remove the right rear wheel housing liner.

- Remove the rear bumper cover.

- Disconnect the lines - 2 and 3 - by activating the release. Disconnecting the couplings, refer to => [ Coupling, Disconnecting ] Service and Repair.






- Loosen the nut for the lower bumper mount on the body - lower left bubble -, and remove the mount.

- Loosen the bolt and nut - arrows - from the Evaporative Emission (EVAP) canister - 1 -.

- Loosen the EVAP canister from the mount in the longitudinal member and disconnect the connector from the leak detection pump.

- Remove the EVAP canister.

Installing

Installation is performed in the reverse order of removal. When doing this note the following:

• Attach the vent lines so that they click into place. Refer to => [ Coupling, Disconnecting ] Service and Repair.

Tightening Specifications