Right Temperature Door Motor (V159) and Potentiometer/Actuator (G221)

Right Temperature Door Motor (V159) and Potentiometer/Actuator (G221)

Special tools, testers and auxiliary items required

• 5.5 mm Open-End Wrench (T10396)

Removing

- Remove the glove compartment. Refer to Storage Compartments, Covers and Trim.

- Remove right footwell (in the middle console). Refer to Storage Compartments, Covers and Trim.

- Disconnect the connector - 4 - from the right temperature door motor - 3 -.

- Remove the bolts - 5 - (1.5 Nm).

- Loosen the connecting rod - 1 - on the temperature door.

- Remove the right temperature door motor - 3 - and the connecting rod - 1 - from the heater and A/C unit.

- Disconnect the adjusting lever - 2 - for the right temperature door motor - 3 - from the connecting rod - 2 -.






Installing

Install in reverse order of removal.

• After installing the right temperature door motor, recirculating air door must be checked for function.

• Perform a "basic setting" using the Vehicle Diagnostic Tester. Refer to => [ Checking and Adjusting Components, Automatic Control System ] Checking and Adjusting Components, Automatic Control System.

• Check and erase the DTC memory.