Oil Separator

Oil Separator

Special tools, testers and auxiliary items required

• Torque Wrench (5-50 Nm) (V.A.G 1331)

Removing

- Remove the noise insulation..

- Remove the bolts in sequence - 9 through 1 - and remove the oil separator.






Risk of contaminating the lubricating system.

• Seal the opening with a clean cloth.

Installing

• Always replace gaskets and seals.

• Only use approved clamps for hose connections. Refer to the Parts Catalog.

Install in the reverse order of removal. Note the following:

- Tighten the bolts in sequence - 1 through 9 -.






Tightening specification: 9 Nm