Removal and Replacement

Breather Assembly

Hose/Line Assembly or Line - 4 - to Breather Assembly - 1 -





- To remove, pull out the clip - 2 - with a screwdriver or a pointed tool and pull out the hose/line assembly or line - 4 - from the breather assembly - 1 -.

- To install, press the hose/line assembly or line with a new seal/O-ring - 3 - into the breather assembly, until the clip audibly engages.

- Pull on the hose/line assembly or line to make sure it is secure.

Breather Assembly - 4 - from Clutch Slave Cylinder





- To remove, pull out the clip - 2 - with a screwdriver or a pointed tool and remove the breather assembly - 4 - from the clutch slave cylinder - 1 -.

- Check the seal/O-ring - 3 - for the clutch slave cylinder. Press on the breather assembly at the clutch slave cylinder until the clip - 2 - audibly engages.

- To check, pull on the breather assembly.

- Bleed the clutch system. Refer to => [ Clutch System, Bleeding ] Procedures.