Brake Pedal and Brake Booster, Separating and Connecting

Brake Pedal and Brake Booster, Separating and Connecting

Special tools, testers and auxiliary items required

• Release tool (T10159)

Separating

- Remove the instrument panel trim panel in the footwell on the driver side.

- If present, remove the crash bolsters.

- If present, remove the knee airbag.

- First press brake pedal in direction of brake booster and hold.






2 Pressure rod
3 Retaining lugs

- Insert the (T10159) and pull it toward the driver seat while applying counter pressure against the brake pedal.

• The pedal assembly must not move toward the rear while doing this.

• This will cause the tabs - 3 - to be pushed out of the push rod ball head mount- 2 -.

- Pull (T10159) and brake pedal together toward the driver seat.

This will pull the brake pedal off.

Connecting

- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster until the ball head engages audibly.






- Check the lock by pulling on the brake pedal.

Tightening Specification