Front Interior Lamp (W1)

Front Interior Lamp (W1)

Removal

When removing and installing components in visible area (switches, covers, trim, etc.), cover by taping the areas at which a prying tool (plastic wedge, screwdriver) will be positioned using commercially available adhesive tape.

- Turn off the ignition and all electric consumers and remove the key.

- Unclip the lens- 1 - - arrows -.






- Remove both screws - arrows - and remove the front interior lamp from the roof trim panel - 1 -. Pay attention to the wires still connected.






- Depending on the vehicle equipment level, disconnect the connectors and remove the interior lamp.

Installation

Install in reverse order of removal. Note the following:

- Tighten the screws to 2 Nm.