Glass Panel

Glass Panel

Removing






Perform the following:

- Open the glass panel - 2 - so that the trims - 1 - are accessible.

- Push the trims - 1 - backward out of the vehicle interior in the - direction of the arrow -.

• When removing the screws, use a magnetic tool so that the screws cannot fall into the panorama sunroof mechanism.






- Remove the seal - 3 - from the assembly frame.

- Remove the left and right screws - 2 - from the glass panel - 1 -.

- Remove the glass panel upward - arrows -.

Installation

• New screws are to be used when installing the glass panel.

• When installing the screws, use a magnetic tool so that the screws cannot fall into the panorama sunroof guide.






Perform the following:

- If necessary, move the tilting mechanism - 3 - on both sides so that the markings - 5 - form one line - arrows b -.

- Insert the glass panel - 1 - from above - arrows a - in the tilting mechanism - 3 - and install but do not tighten the screws - 2 -.

- Adjust the front glass panel.

- Tighten the bolts - 2 -, tightening specification: 7 Nm.






- Install the trim - 2 - on the glass panel - 1 - and slide onto the fasteners.

- After completing all the work, perform an sunroof motor adaptation. Refer to => [ Panorama Sunroof Adaptation ] Panorama Sunroof Adaptation.