Rear Center Console Trim

Rear Center Console Trim

Removing

- Turn off the ignition.

- Remove the rear air vents.

- If present, disconnect the harness connector of the A/C display control head.

- Remove the 2 screws - 1 - (1.5 Nm).






- Detach the trim - 2 - in the lower area - arrow A -.

- Tilt the trim up until it disengages audibly.

- Remove the trim from the center console - arrow B -.

- Disconnect connectors.

Installation

- To install, perform the steps used for removal in reverse order.

• Fold up the armrests after installation of the trim. Then ensure proper engagement between the trim and center console in the area of the armrests.

• After installation of the trim, ensure correct lateral seam alignment between the trim and the center console.