Rear Window Wiper Arm

Rear Window Wiper Arm

Special tools, testers and auxiliary items required

• Torque Wrench (V.A.G 1331)

Removal

- Allow the wiper to move to the park position.

- Fold cover cap - 1 - of rear window wiper up and unclip it.






- Loosen nut - arrow - but do not remove completely.

- Fold up wiper arm and remove from cone moving it sideways.

- Remove the nut - arrow - and remove the wiper arm.

Installation

- With the ignition on, switch the rear wiper on and off again to move the wiper motor into the park position.

- Insert wiper arm on wiper arm shaft at approximate rest position and hand-tighten nut - arrow -.






• Only tighten the wiper arm mounting nut - arrow - to the specification after adjusting the park position.

- Set rest position of rear window wiper. Refer to => [ Rear Window Wiper Blade Park Position, Adjusting ] Rear Window Wiper Blade Park Position, Adjusting.