Wheel Bearing Housing Bonded Rubber Bushing

Wheel Bearing Housing Bonded Rubber Bushing

Special tools, testers and auxiliary items required

• Installing tool (30 - 506 B)

• Impact sleeve (41 - 501)

• Sleeve (3160)

• Assembly tool (3301)

• Assembly tool (3346)

• Assembly tool (3350)

• Torque wrench (V.A.G 1332)

Removing

- Remove the wheel.

- Remove coil spring. Refer to => [ Coil Spring ] Coil Spring.

- Remove brake carrier and brake caliper and tie to body with wire.

• Suspend brake caliper from body.

- Remove the bolt and then remove the brake disc.

- Remove cover plate.

- Remove bolt - arrow - for lower transverse link - 1 -.






Pressing Out Bonded Rubber Bushing

- Attach tools as depicted in illustration.






1 (3346/3)
2 (3301)
3 (3301/3)
4 (41-501)
5 (3350/1)
6 (3346/2)

- Remove bonded rubber bushing by turning spindle.

Pulling In Bonded Rubber Bushing

- Attach tools as depicted in illustration.






1 (3346/3)
2 (3301)
3 (30-506 B)
4 Bonded rubber mount
5 (3160)
6 (3350/2)
7 (3346/2)

- Install bonded rubber bushing by turning support arm bearing installation tool.

• Do not use lubricant!

• Insert bearing with care so it is not canted.

Installing

Installation is the reverse of removal, with special attention to the following:

• Connections to wheel bearing housing may only be carried out of dimension between wheel hub center and lower edge of wheel housing, measured before assembly, is achieved! Refer to => [ Before lifting the axle on one side, the vehicle must be secured on both sides to the lift arms of the lift using. ] Rear Axle, Lifting to Curb Weight Position.

Tightening Specifications