Front Side Marker Lamp

Front Side Marker Lamp

• It is not necessary to disconnect the battery ground cable.

• Removing and installing the left front side marker lamp is shown in the illustrations.

• Removing and installing the right front side marker lamp is identical.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Depending on the vehicle equipment level, either remove the bolt - arrow - in the wheel housing or remove the front section of the wheel housing liner.






- Press the tab - 1 - in - direction of arrow - and remove the side marker lamp - 2 -, from the bumper cover.






- Pull the bulb socket and bulb - 1 - out of the side marker lamp housing.






- Remove the side marker lamp.

Installation

Install in reverse order of removal, noting the following:

• When installing the bulb socket, pay attention to the housing; the openings under the rubber seal must align with the tabs on the housing.

- Install the bulb socket into the bulb housing.

- Insert the front of the side marker lamp - 2 - with the tab - 3 - into the opening in the bumper cover. Then press the back of the side marker lamp - 1 - until it audibly engages.






- Make sure the side marker lamp works correctly.