Sill Panel Trim, 4-door

Sill Panel Trim, 4-door

• The following describes removing and installing on the left side of the vehicle. Removing and installing on the right side is identical.

Removing

- Remove the rear bench seat from the front anchors. Refer to => [ Bench Seat ] Bench Seat.

• It is not necessary to completely remove the rear seat bench.



- Remove 4-door vehicle wheel housing trim in sill panel strip transition area from mount.

- Pull sill panel trim out of front sill panel and door seal piping.

- Remove the guide - 1 - from the B-pillar lower.

- Pull sill panel trim out of rear sill panel and door seal piping.

- Remove the guide - 2 - from the B-pillar lower.

- Open strap - 3 - and feed seat belt through it.

• Check the six clip for damage and replace if necessary.






Installing

- Install in reverse order of removal.