Windshield Washer Pump: Service and Repair

Windshield Washer Pump (V5)

• Depending on equipment, the component location of the Windshield Washer Pump (V5) may deviate slightly from the illustrations. Removal is identical.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove front bumper cover.

• In order to prevent interchanging washer fluid line connections at windshield washer pump, connections at pump and hose lines are color-coded. The hose connectors must be connected to the corresponding colored pump connections during installation.

- To release, twist the securing clips at hose connections - 3 - and - 5 - and disconnect them from windshield washer pump - 4 -.






- If necessary, collect the draining fluid in a suitable container.

- Remove windshield washer pump - 4 - upward out of tank.

- Disconnect electrical connection - 2 -.

Installation

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to specified torques. Refer to => [ Windshield Wiper and Washer System, Tightening Specifications ] [1][2]Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to=> [ Headlamp Washer System, Bleeding ] Headlamp Washer System, Bleeding.