Output Shaft Seal

Output Shaft Seal

Special tools, testers and auxiliary items required

• Puller (T10055)

• Adapter (T10055/2)

• Press Tool for Shaft Seal (T10180)

• Sleeve for Shaft Seal (T10186)

Removing

- Remove the transmission. Refer to => [ Transmission, Removing ] Transmission, Removing.

- To remove the seal, screw in a sheet metal screw - arrow - of approximately 4 mm in diameter into the seal.





• Screw in the sheet metal screw so that it jams between the seal and the metal ring.

• Do not screw in the sheet metal screw too far as to avoid damaging the bearing behind it.

- Remove the seal using (T10055) and the screw.

Installing

- The new seal must be lubricated with Automatic Transmission Fluid (ATF), especially at the sealing lips.





- Install the (T10180) onto the output shaft, so that the seal cannot be damaged.





- Drive in the new seal until seated using (T10180). Do not tilt the seal when doing this.

- Check the ATF level. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] Automatic Transmission Fluid Level, Checking and Filling.