Crankshaft Seal, Belt Pulley Side

Crankshaft Seal, Belt Pulley Side

Special tools, testers and auxiliary items required

• Oil Seal Extractor (T40019)

• Assembly Device (T40048)

Removing

- Remove the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.

- Remove the vibration damper.

- Install the inner part of the (T40019) flush with the outer part and secure using the knurled head screw.





- Lubricate the threaded head of the seal remover, place against the seal, and with strong force screw into the seal as far as possible.

- Loosen the knurled head screw and turn the inner portion against the crankshaft until the seal is pulled out.

- Secure the seal remover in a vice on the flat spots. Remove the seal using pliers

- Clean the running and sealing surface.

Installing

- Install (T40048/1) onto (T40048/2) and slide the seal - 1 - onto the (T40048/2).





- Remove the (T40048/1).

- Place the (T40048/2) on the crankshaft and slide the seal - 1 - into the sealing surface on the engine.





• The (T40048/2) remains on the crankshaft for installation.

- Position the (T40048/4) (installation depth: 5 mm) on the crankshaft with 2 M8 x 55 mm bolts - arrows -.





- Install the bolts by hand.

- Tighten each bolt 1/2 rotation by alternating sides to press in the seal until it is seated.

- Install the vibration damper.

- Install the ribbed belt. Refer to => [ Ribbed Belt ] Ribbed Belt.