Transmission Fluid, Draining and Filling

Transmission Fluid, Draining and Filling

Special tools, testers and auxiliary items required

• Vehicle Diagnosis, Testing and Information System (VAS 5051)

• Adapter for Oil Filling (VAS 6262 A)

• Adapter for Filling ATF Oil (VAS 6262/2)

- Turn off the engine.

- Remove the plug - A -.






- Always replace the seal - B -.

- Remove the overflow tube - C -.

- Drain the transmission fluid.

- Install the overflow tube - C -. Refer to => [ Fastener Tightening Specifications ] Specifications.

- Install the adapter for oil filling (VAS 6262/2) to the transmission pan hand tight.






- Shake the fluid bottles before opening.

- Read the information regarding the pipe before installing the adapter for oil filling (VAS 6262 A) to the fluid container. Refer to => [ Shortening the Pipe
on the : ] Transmission Fluid Level, Checking and Filling.

- Fill with 3 liters of transmission fluid. Refer to the Fluid Capacity Tables for the correct fluid.

- Tighten the plug - A - and a new seal - B - by hand.






- Start the engine, shift through all selector lever positions, you must remain in each selector position approximately 10 seconds.

- Check the fluid level and add if necessary. Refer to => [ Transmission Fluid Level, Checking and Filling ] Transmission Fluid Level, Checking and Filling.