Bumper Cover, Front, Street Version

Front Bumper Cover

• Slight changes may have to be made to removal and installation procedures of front bumper cover, depending upon equipment installed in vehicle.

Removing






- Loosen the front left and right wheel housing liner around the bumper cover. Refer to => [ Front Wheel Housing Liner ] Front Wheel Housing Liner

- Remove the wheel covers - 5 - out of the catches near the bumper cover.

- Remove the bolts - 4 - behind the wheel covers.

- Remove bolts - 2 - from below.

- Remove the bolts - 3 -.

A second mechanic is required for the rest of the removal procedure.

- Pull on the corners of the bumper - arrows - to detach it from its mounting brackets - 4 -.

- With a second technician, pull the bumper cover parallel out of mounts on the headlamps.

- Disconnect harness connectors of installed electrical components and hoses.

For additional information regarding the parking aid,

For additional information regarding parallel parking assistance,

- Disconnect the hose coupling on the washer fluid hose.

Installation

To install, perform the steps used for removal in reverse order.

- Press the bumper on the corners back into the mounting brackets.

• When installing front bumper cover, make sure it is guided on parallel on fender.

- Make sure gaps are parallel and note gap dimensions.