Transmission Position Sensor/Switch: Adjustments

Multi-Function Transmission Range Switch, Adjusting

- Place selector lever in position "N".

- Do not bend selector lever cable.

Requirements:

• Selector lever cable has been removed from lever/selector shaft.

• Selector shaft in "N" position

• Mounting bolts of Multi-Function Transmission Range (TR) Switch ( F125) have been loosened

• Lever/selector shaft has been removed

Work procedure:

- Attach adjustment fixture to selector shaft - 2 - and rotate multi-function switch - 1 - far enough until adjustment fixture engages on to tab on connector at multi-function switch.





- Fasten adjustment fixture onto selector shaft - 2 - using bolt - 3 -.

- Tighten bolts - arrows - to 6 Nm.

- Remove adjustment fixture.

- Rest of installation is in reverse order of removal => [ Multi-Function Transmission Range Switch ] Service and Repair.