Shift Mechanism Assembly Overview

Shift Mechanism Assembly Overview





1 Shift mechanism

• Consists of shift rod and shift cover

• Components cannot be separated from each other

2 Backup light switch (F4)

• Tighten to 20 Nm

• Lightly lubricate tab with MoS2 grease

3 Locking pin

• For adjustment of shift mechanism

• Removing => [ Removing locking pin from
shift cover ] Shift Mechanism

• Pressing in => [ Pressing locking pin into
shift cover ] Shift Mechanism

4 Relay lever

• Installed location => [ Installation Position of Transmission Shift
Lever/Actuator Lever ] Service and Repair

5 Bushing

6 Seal

• Pry out with screwdriver

• Installing => [ Drive in sealing ring to stop. ] Shift Mechanism

7 Hex nut, 23 Nm

• Self-locking

• Always replace

8 Transmission shift lever

• Insert so that master spline aligns with shift rod

• Can be replaced with shift mechanism installed

• Installed position => [ Installation Position of Transmission Shift
Lever/Actuator Lever ] Service and Repair

9 Cap

• For transmission breather

10 Lock washer

11 Sealing cap

12 Spring

• Not installed in all transmissions

• Reinstall if present