Drive Plate

Drive Plate

Special tools, testers and auxiliary items required

• Depth gauge

Removing

- Remove the transmission.

- Lock the crankshaft => [ Crankshaft, Locking ] Crankshaft, Locking, and remove the drive plate.

Installing

- Install the drive plate only by using the washer with recesses - 1 - (without compensating shim - 2 -).





- Install new bolts - 3 - and tighten to 30 Nm.

- Check dimension - a - at three points and calculate the mean value.





Specified value: 18.8 to 20.4 millimeter (mm)

• Measure through the drive plate hole to a surface on the control housing cover.

If the specification is not obtained:

- Remove the drive plate again and install shim - 2 -. Tighten bolts - 3 - to 30 Nm again and repeat the measurement.





If the specified value is OK:

- Tighten the bolts to 60 Nm + 90° (1/4) additional turn, the additional turn may occur in several stages).

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

• Remove the (T40069) from the cylinder block and install the locking bolt (30 Nm).