Clutch Pedal

Clutch Pedal

Special tools, testers and auxiliary items required

• Pliers (T10005)

• Torque wrench 5 to 50 Nm (V.A.G 1331)

Removing

- Slide driver's seat toward rear as far as possible and bring steering wheel to highest position.

- Remove cover in driver's side footwell.

- Remove clutch pedal switch (F36) => [ Clutch Pedal Switch ] Service and Repair.

- Remove over-center spring => [ Over-Center Spring ] Over-Center Spring.

- Separate clutch pedal from master cylinder => [ Master Cylinder ] Service and Repair, and push operating rod toward engine compartment until stop.

- Remove nut - A -.





- Loosen bolt until clutch pedal can be removed.

Installing

Installation is in reverse order of removal. Note the following:

• Replace self-locking nut.

- Mount - A - must be located on operating rod - B - of master cylinder.





- Press clutch pedal in direction of - arrow - to engage, ensure correct engaging while doing so.

- Install over-center spring => [ Over-Center Spring ] Over-Center Spring.

- Install clutch pedal switch (F36) => [ Clutch Pedal Switch ] Service and Repair.

- Install cover in driver's side footwell.

Tightening Specification