Wiring Harness With 8-Pin Connector

Wiring Harness with 8-Pin Connector

Removing

- Remove oil pan => [ Oil Pan ] Service and Repair.

- Remove oil strainer => [ Oil Strainer ] Service and Repair.

- Disconnect connectors from hydraulic pressure sensors - 1 - and - 4 -.





- Disconnect harness connectors - 2 - and - 5 -.

• If harness connector is damaged, wiring harness or Transmission Input Speed (RPM) Sensor (G182) or Transmission Output Speed (RPM) Sensor ( G195) must be replaced.

- Remove bolt - 6 -.





- Carefully pull out Transmission Fluid Temperature Sensor (G93) - 7 - together with bracket from valve body.

• Pay attention to mounting of bracket on Transmission Fluid Temperature Sensor (G93) for reinstallation.

- Disengage wiring harness at bracket - 8 -.

- Disconnect connector - 1 - from transmission connector.





- Remove bolt of 8-pin transmission connector.

- Disconnect connector and wiring harness outward from transmission housing.

Installing

Installation is in reverse order of removal. Note the following:

- Replace O-ring on connector.

- Press connector with new O-ring into transmission up to limit stop.

- Tighten bolt of 8-pin transmission connector => [ (Item 24) Bolt, 6 Nm ] Valve Body Assembly Overview.

- Tighten bolt for bracket of Transmission Fluid Temperature Sensor (G93) to 11 Nm.

- Install oil strainer => [ Oil Strainer ] Service and Repair.

- Install oil pan => [ Oil Pan ] Service and Repair.