Shift Interlock Cable: Adjustments

Locking Cable, Adjusting

CAUTION!
Locking cable adjustment must always be performed as described in the following.

Adjustment requirements:

• Locking cable in installation position

• Center console removed.

• Selector lever in position "P".

• Ignition key in removal position.

Adjusting procedure:

• Steering wheel in position fully extended and downward toward floor.

- Loosen bolt - 3 - on mounting bracket.





- Insert Adjustment Pin For Shiftlock 3 (3352A) between locking lever - 1 - and locking cable eyelet - 2 -.

- To compensate for play, pull cable sleeve in direction of - arrow - until it stops.

- Hold cable sleeve firmly in this position.

- It must be possible to remove and insert Adjustment Pin For Shiftlock 3 (3352A) in this position.

- Tighten bolt - 3 - at mounting bracket to 10 Nm.





- Remove adjusting gauge.

- The function of ignition key removal lock must be checked => [ Ignition Key Removal Lock, Checking Function ] Testing and Inspection.