Air Door Actuator / Motor: Service and Repair

Fresh/Recirculating Air Door Motor

Removing

- Remove glove box.

- Disconnect electrical connector - 1 -.





- Remove screw - 3 -.

- Swing motor - 2 - downwards.

- Disconnect motor - 2 - from fresh air/recirculating air door lever.

Installing

Replacement motors are supplied with operating levers in the " recirculating air" position. To ease installation, first do the following:

- Attach electrical connector - 1 - to door motor - 2 -.





- Switch on ignition.

- Operate button for fresh air/recirculating air and observe lever position.

- When the center position is reached, quickly disconnect the electrical connector.

- Insert motor onto the fresh air/recirculating air shaft - 1 -.





• If it is difficult to align and fit the motor to shaft - 1 -, remove Fresh Air Blower (V2), remove Fresh Air Blower (V2) => [ Fresh Air Blower ] Service and Repair and position door/shaft as required.

- Turn motor in direction of - arrow A -.

- Install mounting screw.

- Reconnect electrical connector.