Engine Accessory Bracket: Service and Repair

Accessory Bracket

Special tools, testers and auxiliary items required

• Engine Support Bridge (10 - 222 A)

Removing

- Remove the engine mount bracket. Refer to => [ Engine Mount and Bracket ] Engine Mount and Bracket.

- Remove the high fuel pressure pump. Refer to => [ High Pressure Fuel Pump ] High Pressure Fuel Pump.

- Remove the generator.


The Air Conditioning (A/C) refrigerant circuit must not be opened.

- Remove the A/C compressor from the accessory bracket and secure it to the lock carrier.

- Remove the idler rollers - 1 and 2 - and remove the bolt on the toothed belt guard - arrow -.






- Remove the bolts - 6 through 1 - and remove the accessory bracket.






Installing

Installation is performed in reverse order. When doing this note the following:

• Make sure there are alignment sleeves inside the accessory bracket and replace any that are missing.

• Replace bolts, which have been tightened to a torque angle.

- Tighten the bolts in sequence - 1 through 6 -. Tightening specifications, see - item 5 - in => [ Ribbed Belt Overview ] Ribbed Belt Overview.






- Install the generator.

- Install the high pressure fuel pump. Refer to => [ High Pressure Fuel Pump ] High Pressure Fuel Pump.

- Install the engine mount bracket. Refer to => [ Engine Mount and Bracket ] Engine Mount and Bracket.