Front Passenger Seat Occupant Sensor

Front Passenger Seat Occupant Sensor


If Front Passenger Seat Occupied Sensor (G128) is replaced, also the upholstery, front seat cushion must always be replaced!

Removal

- Mount the (VAS 6136) on the (VAS 6095).

- Remove front seat. Refer to => [ Front Seat ] Front Seat

- Attach the seat to the (VAS 6136).

- Remove front right seat trim. Refer to => [ Right Seat Trim ] Right Seat Trim

Vehicles with Manual Seat Adjustment

- Remove front left seat trim => [ Left Seat Trim ] Left Seat Trim

- Remove bracket and front seat operating lever => [ Front Seat Support and Operating Lever ] Front Seat Support and Operating Lever

Vehicles with Electric Seat Adjustment

- Remove left power seat trim. Refer to => [ Power Seat Trim, Left ] Power Seat Trim, Left

- Remove retainer and power seat bracket. Refer to => [ Retainer and Power Seat Bracket ] Retainer and Power Seat Bracket

All vehicles

- Remove front seat drawer mount. Refer to => [ Seat Drawer Mount ] Seat Drawer Mount

• On vehicles with a luggage pass-through, it is sufficient to fold the backrest forward, it does not have to be removed.

- Remove front seat backrest. Refer to => [ Left Front Seat Backrest ] Left Front Seat Backrest

- Remove cover and upholstery from front seat backrests. Refer to => [ Front Seat Pan Covers and Upholstery ] Front Seat Pan Covers and Upholstery


Front Passenger's Seat Occupied Sensor (G128) - 1 - is secured with seat cushion padding. It is not possible to remove and install separately, sensor must be replaced with upholstery.





Installation

- Press wiring harness in positioning aid area - 1 - in rear padding channel.

- Press the wiring harness into the recess in the padding at the areas indicated by the - arrows A and B -.

- Align sensor positioning aid - 3 - with padding positioning aid - 2 -.


Ensure distance from sensor to positioning aids - 2 - is constant - arrows - when doing this.





- Secure aligned sensor - 1 - with right hand, remove adhesive tape strips - 2 - and attach sensor to padding.

- Press wiring harness in rear area into padding opening - arrow -.

- Connect wiring harness with vehicle electrical system.





Installing of remaining components is reverse of removal.

- After installing, perform a function check with ignition on.