Separating and Connecting Brake Pedal and Booster

Separating and Connecting Brake Pedal and Booster

Special tools, testers and auxiliary items required

• Release tool (T10159)

Separating

- Remove trim on driver side..

Only on vehicles with brake light switch on mounting bracket:

- Disconnect connector from Brake Light Switch (F).

- Remove brake light switch by rotating 45° toward left.

Procedure for all vehicles:

- First press brake pedal in direction of brake booster and hold.





2 Pressure rod
3 Retaining lugs

- Insert (T10159) and pull in direction of driver seat. When doing this, counter-hold on brake pedal. (At this moment the pedal must not be allowed to move backward). The mounting retaining lugs - 3 - will thereby be pressed off the ball head of the push rod - 2 -.

For ease of illustration separating the brake pedal from the brake booster is shown with the pedal assembly removed.

- Pull (T10159) and brake pedal together toward the driver seat. (The brake pedal will thereby be pulled off the ball head of the push rod).

Connecting

- Hold ball head of push rod in front of mounting and push brake pedal in direction of brake booster, so the ball head locates audibly.





Further installation is in the reverse sequence to removal.

- Install and adjust Brake Light Switch (F). Refer to => [ Brake Light Switch, through 10.05.2005 ] .