iPod Baseplate (R192), Troubleshooting

iPod Baseplate (R192), Troubleshooting

Special tools, testers and auxiliary items required

• Hand-Held Multimeter (V.A.G 1526C)

• Connector Test Kit (V.A.G 1594C)

The iPod baseplate does not have OBD.

The voltage supply can be checked at the connector.

Test Conditions

• iPod OK, refer to the Operating Instructions.

• iPod RESET performed, refer to the Operating Instructions.

• Fuse OK.

• Radio/Radio Navigation System no faults using Vehicle Diagnostic, Testing and Information System (VAS 5051B).

Procedure

- Remove the iPod baseplate. Refer to => [ iPod Baseplate ] iPod Baseplate (R192).

- Disconnect the connector under the iPod baseplate.

- Switch on the Radio.

- Measure the voltage between contacts 3 and 6 as well as between contacts 3 and 8 on the wiring harness connector using (V.A.G 1526C) and the cables from the (V.A.G 1594C).

Specified value: approximately 12 V.

- Switch radio off.

Voltage values not OK:

- Check the wire connection between the radio and the iPod baseplate according to the wiring diagram.

Voltage values OK:

- Replace the iPod baseplate.