Rear Door Window Motor: Service and Repair

Rear Door Window Regulator Motor

• Removing and installing the right window regulator motor is described here. Removing and installing the left window regulator motor is identical.

Removing






- Remove door trim.

- Fix window using adhesive tape so that it does not slip down.

- Remove the three bolts - 2 -.

- Disconnect the connector - 3 -.

- Remove window regulator motor with control module - 1 - from subframe.

Installation


It is necessary to code the additional functions and pinch protection each time a new window regulator motor (door control module) is installed.






- Install the window regulator motor - 1 - and pull door window up and down so that splines are located better between motor and cable drum.

- Connect the connectors - 3 -.

Tightening specification for the bolts - 2 -: 3.5 Nm

- Code a new window regulator motor with (Vehicle diagnostic tester).

- After coding, let the window regulator work in the one-touch up/one-touch down mode and pull the switch for 2 seconds. This way the window regulator recognizes it upper stop.

- Continue by performing the steps used in removal in reverse order.