Left and Right Front Body Acceleration Sensor Retainer

Left and Right Front Body Acceleration Sensor Retainer

Special tools, testers and auxiliary items required

• Torque wrench (V.A.G 1331)

• Drift (VW 222 A)

• Spiral bore diameter: 11 mm

Removing

- Remove the left and right front body acceleration sensors (G341/G342). Refer to => [ Left and Right Front Body Acceleration Sensor ] Left and Right Front Body Acceleration Sensor.

- Remove the retainer bolts and remove the retainer from the shock absorber dome.






Installing


The body acceleration sensors must not be interchanged. Allocation, refer to the Electronic Parts Catalog (ETKA).

- Clean the shock absorber dome.

Front Left Body Acceleration Sensor (G341)

- Attach the acceleration sensor to the retainer.

- Be sure to pay attention to the installation position of the acceleration sensor retainer.






The tab on the retainer - 1 - must fit into the recess in the acceleration sensor - arrow -.

• Be sure to use the correct retainer. An "LA" is stamped on the retainer

Right Front Body Acceleration Sensor (G342)

- Attach the acceleration sensor to the retainer.

- Be sure to pay attention to the installation position of the acceleration sensor retainer.






The tab on the retainer - 1 - must fit into the recess in the acceleration sensor - arrow -.

• Be sure to use the correct retainer. An "R" is stamped on the retainer.

Continuation for Both Sides

- Remove the adhesive on the sealing surfaces of the retainer and apply two-sided adhesive tape.

- Using an 11 mm drill, secure the retainer and the (VW 222 A).






• The holes in the retainer must align with the holes in the shock absorber dome.

- Install the screws on after the other by hand and then tighten to the tightening specification.

- Connect the connector to the body acceleration sensor.

Tightening Specifications