Seal, Transmission Side

Seal, Transmission Side

Special tools, testers and auxiliary items required

• Assembly Tool (T10122)

• Pulling Hook (T20143)

Removing

- Remove the transmission.

- Lock the crankshaft. Refer to => [ Crankshaft, Locking ] Procedures.

- Remove the flywheel or drive plate and remove the sensor wheel for the engine speed sensor (G28) from the crankshaft.

- Pull out the seal using the pulling hook (T20143/2).






Be careful not to damage the sealing surface on the crankshaft.

Installing

• Do not lubricate or grease the sealing lip on the seal.

- Clean the sealing surfaces. They must be free of oil and grease.

- Before installing, remove any remaining oil from the crankshaft journal with a clean cloth.

- Insert the assembly device (T10122/1) onto the pull sleeve (T10122/2) and slide the seal - A - onto the pull sleeve.






- Remove the assembly device (T10122/1).

- Install the pull sleeve (T10122/2) with the seal - A - onto the crankshaft.






- Press in the seal all around evenly and flush using the pressure sleeve (T10122/3).

The rest of the installation follows the reverse of the removal procedure. Note the following:

• Remove the locking pin (T40069) from the cylinder block and install the plug.

Tightening Specifications