Headlamp, Spray Jet Telescoping Cylinder

Headlamp, Spray Jet Telescoping Cylinder

• Removing and installing the left spray nozzle lift cylinder is shown in the following illustrations.

• Removing and installing the right spray nozzle is identical.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove spray nozzles with cover cap - 1 - up to stop out of bumper cover.






- Unclip cover cap - 1 - from bearings - arrows - on spray nozzle holder.

- Remove front bumper cover.

- Press the locking clip - arrow - and remove the hose connection from the lift cylinder.






- Remove screw - 1 -.






- Press both tabs together in - direction of arrow - at the same time and pull the lift cylinder - 2 - downward and out of the bumper cover - 1 -.






Installation

Install in reverse order of removal, noting the following:

- Tighten all the threaded connections to the specification given in the assembly overview. Refer to => [ Headlamp Washer System Overview ] Headlamp Washer System Overview.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.