Headlamp Spray Nozzle Holder

Headlamp Spray Nozzle Holder

• Removing and installing the left spray nozzle holder is shown in the following illustrations.

• Removing and installing the right spray nozzle holder is identical.

Removal

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove spray jet with cover cap - 1 - up to stop out of bumper cover.






- Unclip cover cap - 1 - from bearings - arrows - on spray nozzle holder.

- Lift lug - arrow - slightly and pull out spray nozzle holder.






Installation

• Use the spray nozzle bracket to adjust how far the cap on the nozzle is pulled into the bumper cover. The cap will not close if the spray nozzle bracket does not retract far enough. If the spray nozzle bracket moves with too much force, the cap and the bumper cover will get damaged.

- Slide spray nozzle holder into lift cylinder until it engages.

- Place the cap on the spray nozzle holder and lower the lift cylinder.

- Check cover cap for correct seating on bumper cover.

- Adjust cover cap if necessary by shifting spray nozzle holder into a higher or lower catch on the lift cylinder.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.

- Check the spray nozzles for the headlamp cleaning system and adjust if necessary.