Selector Lever Handle

Selector Lever Handle

• There are four recesses in the handle - arrows - for securing the insert. These recesses were changed. When installing the handle, use the correct procedure for installing the insert.

• Only handles with the modified recesses are delivered as replacement parts. The insert remains the same.





I Handle with old recesses

II Handle with modified recesses

Removing

• This procedure applies to all handles.

To ensure the handle is not damaged adhere to this sequence:

- Pry out the insert.





- Remove the retainer from the handle.





- Pull the button past the pressure point until it is locked in position.

- Remove the handle from the selector lever.

Installing

• Note that there are different procedures for installing the insert.

If the button is inadvertently pressed into the handle, hold the handle vertically and at the bottom. Carefully blow the button outwards again using compressed air until it can be pulled out past the pressure point by hand.

- Reinstall the assembly aid - A - (enclosed with the new handle).





- Push in retainer.

Handle with old recesses

- Press the insert into the handle until it stops.

• To make sure that the tabs on the insert are seated correctly in the recesses on the handle:

- Move the insert approximately 1 mm back and forth in the handle by hand.

Handle with modified recesses

- Install the retainer - 2 -.





- I - Press the insert into the handle until it stops then slide it upward - arrow -.





- II - Place the sleeve on the handle.

Continuation for All Handles

- Place the selector lever in the "N" position.

- I - Guide the sleeve carefully through the cover strip/frame and the cross slide lying underneath.





- Guide the sleeve carefully through the cover strip/frame when inserting. If carelessly pushing the sleeve in, the cover strip will break.

- II - Install the handle lengthwise until seated, then turn.

Installed position: button facing driver.

- III - Press the handle on the selector lever until it is seated and engages noticeably.

- Remove the assembly aid - A -, operate the button and remove the sleeve upward.

- Remove the protective foil from the insert and affix the emblem - arrow -.