12-way Seat Height Inclination Drive Motor

12-way Seat Height Inclination Drive Motor

Removing

- Remove belt anchor. Refer to => [ Belt Anchor ] Belt Anchor

- Position seat as far up as possible using height adjustment.

- Remove 12-way seat. Refer to=> [ 12-way Seat ] 12-way Seat

- Mount the fixture for seat repair (VAS 6136) on the engine and transmission holder (VAS 6095).

- Secure 12-way seat on fixture for seat repair (VAS 6136).

- Remove connector - 3 - from seat inclination adjustment drive motor - 2 -.

- Remove bolt - 1 - (20 Nm).

• When removing screws - 4 - and - 5 -, seat inclination adjustment drive motor - 2 - must be secured against falling down.

- Remove the two screws - 4 - and - 5 - (12 Nm).

- Remove drive motor from seat longitudinal adjuster.





Installation

- To install, perform the steps used for removal in reverse order.