Lock

Lock

Removing

- Open the bracket for spare wheel - 1 -.





- Remove bolts - 3 - (quantity: 6) and pull the lock - 2 - out from the bracket for spare wheel - 1 -.

- Separate applicable electrical connectors.

Installing

CAUTION!
The specified bolting sequence 1 - 6 must be strictly maintained.

Installation of lock - 2 - is the same in reverse order.





- Lightly fasten bolts - 3 - in the specified bolt sequence - 1 - through - 6 -.

- Then tighten hex nuts - 3 -. Tightening specification: 8 Nm.