12-way Front Seat Cushion Cover and Upholstery

12-way Front Seat Cushion Cover and Upholstery

• Removal and installation of the components is described for the left-hand seat. The same instructions apply for removal and installation of components for right seat.

Removing

- Remove belt anchor. Refer to => [ Belt Anchor ] Belt Anchor.

- Remove 12-way seat. Refer to => [ 12-way Seat ] 12-way Seat.

- Remove backrest hinge trim for 12-way seat. Refer to => [ 12-way Seat Backrest Hinge Trim ] 12-way Seat Backrest Hinge Trim.

- Remove trim for 12-way seat. Refer to => [ 12-way Seat Trim ] 12-way Seat Trim.

- Remove backrest for 12-way seat. Refer to => [ 12-way Seat Backrest ] 12-way Seat Backrest.

- Remove profile - 1 - from receptacle.

- Open all profiles and cover attachments.

- Separate cover around seat base and fold outer edge - 2 - upward.





- Cut through upholstery clips - 1 - using suitable pliers.

• In vehicles with the "W12" and the "R-Line" and "R 50" interior, the front seat cover is secured to the padding with adhesive strips instead of upholstery clips.

• When removing the cover, loosen it from the padding carefully to avoid tearing it.

• When installing the cover, use upholstery pliers (V.A.G 1634) to the install upholstery clips.

- Separate seat heater wiring harness - 2 -.

- Remove the cover - 3 - and the cushion - 4 - from the seat frame - 5 -.





Installation

- To install, perform the steps used for removal in reverse order.