Bumper Carrier with Cable Winch Mount

Bumper Carrier with Cable Winch Mount

• Installed only on vehicles through 10.2006

• Further information on bumper carrier with cable winch mount can be obtained via Volkswagen Technical Helpline

Removing





- Remove cable winch. Refer to=> Electrical Equipment 94 Removal and Installation.

- Remove left and right signal horns.

- Disengage clips for bumper carrier on left and right sides as described in the chapter for removing and installing bumper carrier. Refer to => [ Bumper Carrier ] Bumper Carrier.

- Remove bolts - 2 - and - 3 - at left and right from bumper carrier - 1 -.

Installation





Installation of bumper carrier - 1 - is the same in reverse order.

Tightening specification for bolts - 2 -: 1.5 Nm.

Tightening specification for bolts - 3 -: 65 Nm.