Ribbed Belt Pulley With Freewheel, Bosch

Ribbed Belt Pulley With Freewheel, Bosch

Special tools, testers and auxiliary items required

• Multi-Tooth Adapter (VAS 3400)

• Torque Wrench (V.A.G 1332)

Removing

- Remove generator.

- Tighten the generator in a vise at the mounting points.

- Remove the cap from the ribbed belt pulley with freewheel.

- Insert (VAS 3400) into the generator ribbed belt pulley with freewheel using a 17 mm open-end wrench.

- Insert a multi-point socket insert M10 - 1 - in generator shaft.






- Hold the generator shaft and loosen the ribbed belt pulley with freewheel by turning it to the left using an open-end wrench.

- Hold the ribbed belt pulley with freewheel steady. Turn the generator input shaft until it is possible to remove the ribbed belt pulley with freewheel.

Installing

Installation is performed in the reverse order of removal. Note the following:

- Next, screw ribbed belt pulley with freewheel onto generator driveshaft by hand until it reaches stop.

Torque wrench (V.A.G 1332) must be changed for installing the ribbed belt pulley with freewheel as follows:

- Disengage socket - 1 - and pull it off handle part - 2 -.






- Turn around handle part - 2 - of torque wrench 180° and insert socket again.

- Set turning direction of torque wrench to left at socket.

- Insert a multi-point socket insert M10 - 1 - in generator shaft.






- Counterhold the (VAS 3400) with a 17 mm open-end wrench.

- Tighten ribbed belt pulley with freewheel by turning generator driveshaft toward left using (V.A.G 1332).

- Tighten the M10 threaded connection ribbed belt pulley with freewheel to the generator to 80 Nm.