Rear Cup Holder

Rear Cup Holder

If the rear cup holder is defective, then it can be replaced only one time. Replacing the rear trim is not required.

- Switch off ignition.

Vehicles with Multi Media System

- Remove the multi media control head.

Vehicles with Converter with Socket, 12V, 230V (U13)

- Remove the converter with socket, 12 V-230 VV (U13).

- Remove the center console trim. Refer to => [ Center Console Trim ] Center Console Trim

- Remove the back side of the trim around the weld points - 1 -, to do this use a 10 mm steel drill bit.

- Remove the defective cup holder - 2 - from the trim.

- Install the new cup holder into the trim.

- Melt any remaining plastic tips using a the heated point of a cotter pin driver - 3 -.






- Installing the rear trim is the same as removal, but in reverse order.