B-Pillar Upper Trim, Loosening from Mounts and Securing

B-Pillar Upper Trim, Loosening from Mounts and Securing

• Removing and mounting is described for the right side of the vehicle. Removing and installing for the left side is identical.

Detachment

- Remove the Airbag emblem - 1 - using the trim removal wedge (3409) and remove the screw - 2 - (4 Nm).

- Pull the trim at the bottom downward out of the retainers in the B-pillar trim - arrow A -.

- Remove the trim from the door seal piping.

- Pull trim out of top mounts - arrow B -.






Mounting

• When installing, airbag emblem - 1 - must be replaced.

- Move the seat belt height adjuster - 3 - into the highest position.

- Move the slide - 4 - in the trim to the highest position.

- Install in reverse order of removal.

After installation, perform the following function test on the belt height adjuster:

- Operate height adjuster slide and position height adjuster in highest position.

- Pull seat belt down.

- Height adjuster must engage in highest lock position when doing so.