Windshield Washer Pump: Service and Repair

Windshield and Rear Window Washer Pump (V59)

• Depending on equipment, location of Windshield and Rear Window Washer Pump (V59) may differ slightly from illustrations. Removal is identical.

Removing

- Turn off the ignition and all electric consumers and remove the key.

- Remove the left front wheel housing liner.

• In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump (V59) , connections at pump and hose lines are color-coded. The hose connections must be connected to the corresponding colored pump connections during installation.

- To release, twist the securing clips on the hose connections - 3 - and - 4 - and disconnect them from the windshield and rear window washer pump - 2 -.






- If necessary, collect the draining fluid in a suitable container.

- Remove windshield and rear window washer pump - 2 - upward out of reservoir.

- Disconnect the connector - 1 -.

Installing

Installation is performed in the reverse order of removal. Note the following:

- Tighten all threaded connections to specified torques shown in => [ Windshield Washer System Overview ] Windshield Washer System Overview.

- Bleed headlamp washer system after completing assembly work. Refer to => [ Headlamp Washer System, Bleeding ] Procedures.