Windshield and Headlamp Washer System Reservoir, with Auxiliary Heater

Windshield and Headlamp Washer System Reservoir, with Auxiliary Heater

• Depending on equipment, position of individual components may differ slightly from version shown in illustration. Removal is performed in the same way.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove filler tube for tank for windshield washer system and headlamp cleaning system. Refer to => [ Windshield and Headlamp Washer Fluid Reservoir Filler Neck ] Windshield and Headlamp Washer Fluid Reservoir Filler Neck.

- Remove front bumper cover Removal and installation.

- Move the lock carrier to the service position

- Remove auxiliary heater air intake manifold noise insulation - 11 -

- Unclip bracket of air intake noise damper.

- To release, twist securing clips at hose connections - 3 - and - 5 - and disconnect them from Windshield and Rear Window Washer Pump (V59) - 6 -.





- If necessary, save the drained washer fluid in a suitable container.

- Remove Windshield and Rear Window Washer Pump ( V59) - 6 - upward out of tank and disconnect harness connector - 8 -.

- Disconnect harness connector - 4 - of Windshield Washer Fluid Level Sensor (G33) - 9 -.

- Pull Headlamp Washer Pump (V11) - 3 - upward out of tank and disconnect harness connector - 10 -.

- Unclip hose - arrow - from guide on tank.





- Unscrew mounting bolts - arrows - and pull out tank from bracket toward front.





Installing

Install in reverse order of removal, noting the following:

- Slide tank for windshield washer system and headlamp cleaning system into its bracket from the front.





• When installing, make sure that the three guides of the tank fit correctly into tank recesses - arrows -.

- Secure tank with bolts - arrows -.





- Reinstall air intake noise damper for parking heater.

- Tighten all threaded connections to specified torques. Refer to=> [ Specifications ] Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.