Sunroof / Moonroof Panel: Service and Repair

Sunroof Glass Panel

Removing

- Remove bellows => [ Bellows ] Bellows.

- Remove mounting bolts - 1 - on left and right sides.





- Remove glass panel for sunroof - 2 - upward.

CAUTION!
Slotted guide rail must not be driven into "opened" position with sunroof glass panel removed because the rain channel is no longer pressed down by the glass panel and may be wedged in roof.

Installing

• The panel must be installed in the neutral position (panel closed).

Neutral Position

Marking - arrow - on upper part of rear guide - 1 - must be located on both sides between markings dimension - a - at slotted guide rail - 2 -.





Link guide - 2 - must be engaged in guide rail (cannot be moved by hand).

If this is not the case, adjust parallel movement => [ Parallel Movement, Adjusting ] Parallel Movement, Adjusting

- Insert glass panel for sunroof - 2 - from above and screw in mounting bolts - 1 -.





- Tighten mounting bolts - 1 - lightly.

- Adjust glass panel for sunroof (height adjustment): => [ Sunroof Glass Panel, Adjusting Height ] Sunroof Glass Panel, Adjusting Height

• Tighten bolts after panel height adjustment (4.5 Nm).

• Install bellows after panel height adjustment.