Rear Bumper Cover

Rear Bumper Cover

• Removal and installation may be slightly different depending on the engine installed in the vehicle.

Removing





- Remove tail lamp assemblies

- Remove screws - 5 - in area of left and right wheel housing liner.

- Pry out expanding rivet - 4 - in area of left and right wheel housing liners using a screwdriver.

- Remove bolts - 2 - and - 3 - from below.

- Remove bolts - 6 - from above.

A second technician is required for the rest of the removal procedure.

- With a second technician, pull cover - 1 - parallel out of guide profiles.

- Disconnect connectors of electrical components present, license plate light.

Installing

To install, perform the steps used for removal in reverse order.

- Make sure gaps are parallel and pay attention to gap dimensions