Windshield and Headlamp Washer System Reservoir, without Auxiliary Heater

Windshield and Headlamp Washer System Reservoir, without Auxiliary Heater

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove filler tube for tank for windshield washer system and headlamp cleaning system. Refer to=> [ Windshield and Headlamp Washer Fluid Reservoir Filler Neck ] Windshield and Headlamp Washer Fluid Reservoir Filler Neck.

- Remove front bumper cover Removal and Installation.

• In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump (V59), connections at pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

- To release, twist the securing clips at the hose connections - 3 - and - 5 - and disconnect them from the Windshield and Rear Window Washer Pump (V59) - 4 -.





- If necessary, save the drained washer fluid in a suitable container.

- Disconnect harness connector - 6 - of Windshield Washer Fluid Level Sensor (G33) - 7 -.

- Remove Windshield and Rear Window Washer Pump ( V59) - 4 - upward out of tank and disconnect harness connector - 2 -.

- Pull Headlamp Washer Pump (V11) - 9 - upward out of tank and disconnect harness connector - 10 -.

- Unscrew tank mounting bolts - arrows - and remove tank together with filler tube connecting pipe from vehicle.





Installing

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to specified torques. Refer to=> [ Specifications ] Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.