Windshield Washer Pump: Service and Repair

Windshield and Rear Window Washer Pump

• Depending on equipment, location of Windshield and Rear Window Washer Pump (V59) may differ slightly from illustrations. Removal is performed in the same way.

Removing

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove front bumper cover Removal and Installation.

• In order to prevent interchanging washer fluid line connections at Windshield and Rear Window Washer Pump (V59), connections at pump and hose lines are color-coded. Hose connector pieces must be connected to the corresponding colored pump connections during installation.

- To release, twist the securing clips at the hose connections - 3 - and - 5 - and disconnect them from the Windshield and Rear Window Washer Pump (V59) - 4 -.





- If necessary, collect the draining fluid in a suitable container.

- Remove Windshield and Rear Window Washer Pump ( V59) - 4 - upward out of reservoir.

- Disconnect electrical connection - 2 -.

Installing

Install in reverse order of removal, noting the following:

- Tighten all threaded connections to specified torques. Refer to=> [ Specifications ] Specifications.

- Bleed headlamp washer system after completing assembly work. Refer to=> [ Headlamp Washer System, Bleeding ] Procedures.