Headlamp Range Control Positioning Motor, Visteon

Headlamp Range Control Positioning Motor, Visteon

Removing

• If adjustment motors are removed and installed or replaced, headlamp adjustment must be checked and headlamp must be adjusted if necessary.

• Illustrations depict replacement of headlamp beam adjusting motor at left headlamp.

- Switch off ignition, switch off all electrical consumers and remove ignition key.

- Remove headlamp. Refer to=> [ Headlamps ] Headlamps.

- Rotate cover cap - 1 - in - direction of arrow - and remove it.





- Turn headlamp beam adjusting motor - 1 - in - direction of arrow -.





- Disconnect harness connector - 1 - of headlamp beam adjusting motor - 2 -.





- Move Headlamp Beam Adjusting Motor so ball head - 2 - can be removed in - direction of arrow - from ball head mount - 1 -.





- Remove headlight beam adjusting motor out of headlight housing.

Installing

Install in reverse order of removal, noting the following:

- Carefully insert headlamp beam adjusting motor - 1 - ball head into ball head guide - arrow -.





CAUTION!
When installing the cover cap, make sure the cap is properly seated. It is destroyed by ingress of water into headlamp.

- Check headlamp for function.

- Check headlamp adjustment and adjust headlamp if necessary